Boring Tool MFR for face grooving

Some specifications are as follows. For other sizes, you can consult for customization. If you don’t understand the model, you can click:

Boring Tool Model Analysis Table

Notice:

1. The Boring Tool must be installed before processing
2. To install the Boring Tool, the center height should be 0-5 wires lower than the center height. No higher center is allowed.
3. The linear speed should be above 40m/min under certain conditions.
4. The feed measuring tool is recommended to be within 0.05mm/r
5. Pay attention to chip removal when using it
6. During grooving, cut the large diameter first and then process the small diameter.
7. Transverse cutting is not allowed