Climb milling refers to a machining method in which the movement direction of the tool teeth is the same as the tool feed direction when the tool rotates, as shown in Figure A. During climb milling, the cutting thickness (green area in Figure A) is maximum when the tool tip starts to contact the workpiece, […]

1. milling plane Plane milling uses the circumferential edge or end edge of the milling cutter to feed in a direction parallel to the workpiece plane to form a plane parallel to the feed direction of the workpiece, as shown in Figure 1-1. 2、milling groove 　　Milling groove (usually refers to milling at least one section […]

1. Chip discharge mode: Straight flute taps: The cutting edge is straight and has no helical rise angle, so the chips generated during the tapping process are discharged in a straight direction, usually suitable for through-hole thread processing. Since the chips are discharged directly downwards, for long through holes and continuous production, poor chip removal […]

Material to be processed Pre-hardened steel/quenched and tempered steel<35-48HRC Quenched steel<48-52HRC Quenched steel<48-60HRC diameter Rotation speed (rev/min) Feed speed mm/min Rotation speed (rev/min) Feed speed mm/min Rotation speed (rev/min) Feed speed mm/min cutting depth Side milling ap≤1.5D ae≤0.05D Side milling ap≤1D ae≤0.03D Side milling ap≤1D ae≤0.02D 3 14700 840 13130 530 11550 460 4 7560 […]

Alloy Screwdriver Tap Installation, Punching Off and Unscrewing 1、Installation In general, a manual installation spanner should be used to install the wire sleeve. Wire nut into the installation spanner, rotate the mandrel so that the wire nut through the installation of the spanner on the guide threads screwed into the bottom hole, and make it […]

1、Choose the best hole bottom size This is the most important tip. Look, the tap tapping bottom hole needs to match the bottom hole size. Generally, the corresponding bottom hole size range will be given in the sample. Please note that this is the range. It's important to realize that there is no single tap […]

Chip formation can also show whether the most suitable tool is being used. If chip formation is not up to par, the tool geometry may need to be changed to improve the situation. Clearly, the geometry of the cutting tool has a significant impact on chips. Specifically, increasing the rake angle can improve chip formation, […]